Show Interface Mtu - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Configuration
3.1 System
3.1.1.7
show interface mtu
Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interface mtu [{Vlan<vlan-id(1-4094)>|
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The settings are displayed.
38
or
cli#
<interface-type><interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Range of values
-
1 ... 4094
Enter a valid interface.
Advertisement
Table of Contents
