Spanning-Tree Mst - Siemens SCALANCE W760 Configuration Manual

6.3.4.8

spanning-tree mst

Description
With this command, you configure the various properties of the Multiple Spanning Tree
function:
● With the
● With the
Multiple Spanning Tree configuration.
● With the
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst<instance-id(1-64)>
The parameters have the following meaning:
Parameter
instance-id
cost
port-priority
disable
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
option, you configure the port costs used to calculate the lowest-cost path.
cost
option, you configure the priority of the interface for negotiating a
port-priority
option, you disable the interface for the Multiple Spanning Tree function.
disable
{cost(0-200000000)|port-priority (0-240)|disable}
Description
Number of the addressed instance
Costs of the port for calculating the
lowest cost path.
Priority of the interface
disables the interface for multiple
spanning tree
Network structures
6.3 Spanning Tree
Range of values / note
1 ... 64
0 ... 200000000
Default:
200000 for physical interfaces
•
199999 for port channels
•
0 ... 240 in steps of 16
Default: 128
-
Default:
The Multiple Spanning Tree func-
tion is enabled on the interface
249