Snmp Targetaddr - Siemens SCALANCE W760 Configuration Manual

Network protocols
7.4 SNMP
7.4.2.14

snmp targetaddr

Description
With this command, you configure the SNMP target address.
Requirement
● The SNMP target parameters are configured.
You are in the Global Configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName>{ipv4 <ip address> | fqdn-name
<FQDN(100)>}
[timeout <Seconds(1-1500)][retries <RetryCount(1-3)]
[taglist <TagIdentifier|none>][{volatile|nonvolatile}]
[port <integer(1-65535)>]
Parameter
TargetAddressName
param
ParamName
ipv4
ip address
fqdn-name
FQDN(100)
timeout
Seconds
retries
RetryCount
taglist
320
Description
Name of the target address
Keyword for the parameter name
Name of the parameter
Keyword for an IP address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Do-
main Name)
Keyword for the time the SNMP
agent waits for a response before it
repeats the inform request message
Time in seconds
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
Number of attempts
Keyword for
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values
max. 32 characters
-
max. 32 characters
-
Enter a valid IPv4 unicast address.
-
Maximum of 100 characters
-
1 ... 1500
-
1 ... 3
•
TagIdentifier
•
none
Configuration Manual, 11/2014, C79000-G8976-C351-03