Vlan - Siemens SCALANCE W760 Configuration Manual

Network structures

6.2 VLAN

6.2.2.3 vlan
Description
With this command, you create a VLAN on the device and change to the VLAN configuration
mode.
Note
The device supports up to 2 virtual networks.
In the provider backbone bridge mode, this command is used to create user, service and
backbone VLANs.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
Do not enter any leading zeros with the number of the VLAN.
Result
The VLAN is created.
You are now in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Further notes
You delete the VLAN with the
You can display information about the VLAN with the
204
Description
Number of the addressed VLAN
command.
no vlan
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values
1 ... 4094
command.
show vlan
Configuration Manual, 11/2014, C79000-G8976-C351-03