Syntax
Call up the command with the following parameter:
fault report ack <fault-state-id>
The parameter has the following meaning:
Parameters
fault-state-id
Result
The message is acknowledged.
11.1.13
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.1.13.1
events
Description
With this command, you change to the EVENTS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
events
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Value
ID of the mes-
Enter the ID of the message for the "Cold/Warm Start"
sage
event.
To obtain the ID, use the "
command.
configure terminal
show events faults status
command to change to this mode.
or
command and are then in the
end
exit
Diagnostics
11.1 Diagnostics
"
411