Spanning-Tree Mst Max-Hops - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.3 Spanning Tree
Result
The "root bridge" function is disabled.
Further notes
You enable the root bridge function with the
You display this setting and other information with the commands that start with
spanning tree ...
6.3.3.12
spanning-tree mst max-hops
Description
With this command, you configure the maximum number of nodes (hops) that a path can run
through in an MST.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
value
Result
The setting for the maximum number of hops is configured.
Further notes
You can reset the setting for the maximum number of nodes to the default with the
spanning-tree mst max-hops
You display this setting and other information with the
configuration
236
.
Description
Maximum number of hops that a path
can run through in an MST
command.
command.
spanning-tree mst instance-id root
Range of values / note
6 ... 40
Default: 20
show spanning tree mst
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
show
no
Advertisement
Table of Contents
