Show Wlan Antennas; Show Wlan Ap (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
6.1.1.3
show wlan antennas
Description
This command shows the antenna settings for the device, for example cable length.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan antennas <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The antenna settings of the relevant WLAN interface are displayed.
6.1.1.4
show wlan ap (access point)
Description
The command displays the configuration parameters of the access point.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
cli#
Description
WLAN interface
or
cli#
Values or range of values
Enter a valid interface.
Network structures
6.1 WLAN
119
Advertisement
Table of Contents
