No Syslogserver - Siemens SCALANCE W760 Configuration Manual

11.2.2.2

no syslogserver

Description
With this command, you configure the Syslog server address.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Syntax
Call up the command with the following parameters:
syslogserver {ipv4 <ucast_addr> | fqdn-name <FQDN(100)>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN(100)
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The settings for the Syslog server are disabled.
Further notes
You enable the setting with the
You can display the status of this function and other information with the
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Keyword for an IP address
Syslog server IPv4 Address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
command.
syslogserver
Diagnostics
11.2 Syslog client
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
show events config
425