No Ntp Server; Ntp Time Diff - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
System time
5.2 NTP client
5.2.3.2
no ntp server
Description
With this command, you delete the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call the command without parameter assignment:
no ntp server
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The connection to a server is deleted on the NTP client.
Further notes
You configure the connection to a server with the
5.2.3.3
ntp time diff
Description
With this command, you configure the time difference between the device and the NTP
server.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
108
command.
ntp server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Advertisement
Table of Contents
