Static-Lease Mac - Siemens SCALANCE W760 Configuration Manual

7.3.4.10

static-lease mac

Note
The command is only available when the following requirements are met:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• The IPv4 address band is not enabled.
Description
With this command you specify that devices with a certain MAC address are assigned to the
selected IPv4 address. A maximum of 20 assignments are possible.
Requirement
● The assignment has not yet been created.
● You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
static lease mac <mac-address><ip-address>
The parameters have the following meaning:
Parameter
mac-address
ip-address
Result
The assignment is specified.
Further notes
You display the setting with the
You disable the IPv4 address band with the
You delete the assignment with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Unicast MAC address
Unicast IPv4 address
show ip dhcp dhcp-server bindings
no pool-enable
no static-lease mac
Network protocols
7.3 DHCP server
Range of values / note
Specify the MAC address.
aa:bb:cc:dd:ee:ff
Enter a valid IPv4 address.
command.
command.
command.
299