Show Dcp Server; Show Ip Route - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network protocols
7.1 IPv4 protocol
Result
The overview of the DCP forwarding behavior is displayed.
7.1.1.2
show dcp server
Description
This command shows whether or not the DCP function is enabled on the device.
If the DCP function is enabled, the read and write permissions are displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show dcp server
Result
The overview of the status of the DCP function and access rights is displayed.
7.1.1.3
show ip route
Description
This command shows the routes currently being used.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|static}]
260
or
cli#
or
cli#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Advertisement
Table of Contents
