Show Wlan Client-List-Vap (Access Point); Show Wlan Data Rates (Access Point) - Siemens SCALANCE W760 Configuration Manual

6.1.1.10

show wlan client-list-vap (access point)

Description
This command shows the VAP interface via which the clients are logged on to the access
point in the form of a table.
Note
The command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan client-list-vap vapX 0/Y [AID]
The parameter has the following meaning:
Parameter
vapX 0/Y
AID
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The table with the logged-on clients is displayed.
6.1.1.11

show wlan data rates (access point)

Description
This command shows the tables with the available data transmission speeds.
Note
This command is available only in access point mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
cli#
Description
VAP interface
Connection ID of the
client.
Values or range of values
Enter a valid interface.
-
Network structures
6.1 WLAN
125