Dcp Server - Siemens SCALANCE W760 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call up the command with the following parameters:
no ip route <gateway>
The parameter has the following meaning:
Parameter
gateway
Result
The entry is deleted.
Further notes
You configure an entry from the IP routing table with the
You display the IP routing table with the
7.1.2.7

dcp server

Description
With this command, you configure the read and write permissions for the DCP server and
enable it.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
dcp server {read-only|read-write}
The parameters have the following meaning:
Parameter
read-only
read-write
268
Description
Specifies the IP address of the gateway.
Description
only reading is permitted on the DCP
server
reading and writing is permitted on the
DPC server
Range of values
Specify a valid IP address.
ip route
command.
show ip route
Range of values / note
-
Default:
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
read-write