Syntax
Call up the command with the following parameters:
no spanning-tree[mst <instance-id(1-64)>]priority
The parameters have the following meaning:
Parameter
mst
instance-id
Result
The priority of the device is reset to the default value.
Further notes
You configure the setting with the
You display this setting and other information with the commands that start with
spanning tree ...
6.3.3.16
Time settings for the Spanning Tree protocol
spanning-tree
Description
With this command, you configure the various time settings of the spanning tree function:
● With the
spanning tree status from "Blocking" to "Forwarding".
● With the
configuration BPDUs.
● With the
becomes invalid.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Keyword for a Multiple Spanning Tree
instance
Number of the instance
spanning-tree priority
.
option, you configure the time after which a port changes its
forward-time
option, you configure the time after which the bridge sends its
hello-time
option, you configure the time after which the information of the BPDUs
max-age
Network structures
6.3 Spanning Tree
Range of values / note
-
1 ... 64
command.
show
239