Nat Local Ip Address (Client) - Siemens SCALANCE W760 Configuration Manual

Layer 3 functions
9.1 NAT
See also
show nat (client) (Page 349)
9.1.3.3

nat local ip address (client)

Description
With this command, you configure the IP address of the Ethernet interface. This IP address
is the gateway address of the local device.
Note
This command is only available in the client mode
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
nat local ip address <ip-address> {<subnet-mask>|/<prefix-length(0-32)>
The parameters have the following meaning:
Parameters
ip-address
subnet-mask
prefix-
length
Result
The local IP address of the Ethernet interface is configured.
Further notes
You show the NAT configuration and the translation list with the
See also
show nat (client) (Page 349)
354
Description
Address of the Ethernet interface
Subnet mask of the local Ethernet
Decimal representation of the mask as
a number of "1" bits
Values
enter a valid IP address
enter a valid subnet mask
1 ... 32
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
show nat