No Authorized-Manager Ip-Source - Siemens SCALANCE W760 Configuration Manual

Security and authentication
10.3 Management Access Control List
10.3.2.2

no authorized-manager ip-source

Description
With this command, you delete an interface via which an authorized manager is allowed to
access the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefixlength(1-32)>}]
The parameters have the following meaning:
Parameter
ip-address
subnet-mask
prefixlength
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
An authorized manager is deleted from the list.
Further notes
You configure the interfaces and protocols via which an authorized manager is allowed to
access the device with the
You show the information about the configuration of the authorized managers with the
authorized-manager
402
Description
Specifies the network or the IP address
for which the IP manager is authorized
Subnet mask that restricts the authori-
zation
Decimal representation of the mask as
a number of "1" bits
authorized-manager ip-source
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid IP address or a
network
Enter a valid mask
1 ... 32
command.
Configuration Manual, 11/2014, C79000-G8976-C351-03
show