Spanning-Tree L2T-Edge - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.3 Spanning Tree
Result
The automatic discovery of a bridge on the interface is disabled.
Further notes
You enable the automatic detection with the
You can display the status of this function with the
6.3.3.7
spanning-tree l2t-edge
Description
With this command, you specify that an end device can be located at a layer 2 tunnel port.
Otherwise a reconfiguration of the network will be triggered whenever a link to this port is
modified. The L2T clients should be interconnected.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree l2t-edge
Result
The setting is enabled.
Further notes
You disable the setting with the
You can display the status of this function with the
232
spanning-tree l2t-auto-edge
show spanning-tree l2t-edge
no spanning-tree l2t-edge
show spanning-tree l2t-edge
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
command.
command.
command.
Advertisement
Table of Contents
