Commands In The Interface Configuration Mode; Spanning-Tree - Siemens SCALANCE W760 Configuration Manual

Network structures
6.3 Spanning Tree
6.3.4

Commands in the interface configuration mode

This section describes commands that you can call up in the Interface Configuration mode.
Note
The commands are only available with layer 3 and when the interface is a VLAN interface.
In the Interface Configuration mode, enter the
Commands relating to other topics that can be called in the Interface Configuration mode
can be found in the relevant sections.
● If you exit the Interface Configuration mode with the
Interface Configuration mode.
● If you exit the Interface Configuration mode with the
Privileged EXEC mode.
6.3.4.1

spanning-tree

Description
With this command, you configure the various properties of the spanning tree function:
● With the
● With the
● With the
segment. The following settings are possible:
–
–
● With the
is connected to an end device and can therefore ignore the waiting time before changing
to Forwarding mode.
● With the
spanning tree configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
242
option, you configure the port costs used to calculate the lowest-cost path.
cost
option, you disable the interface for the spanning tree function.
disable
option, you configure the connection status of the following network
link-type
– the interface communicates with precisely one network component
point-to-point
- the interface is connected to more than one network component
shared
option, you enable the PortFast function on the interface. The interface
portfast
option, you configure the priority of the interface for negotiating a
port-priority
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03