Nat Interface (Client) - Siemens SCALANCE W760 Configuration Manual

9.1.3.4

nat interface (client)

Description
With this command, you enable NAT for the Ethernet interface.
Note
This command is only available in the client mode
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
● "Own" is set for "MAC Mode".
Syntax
Call up the command with the following parameters:
nat interface <interface-type><interface-id>}
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
NAT is activated for the Ethernet interface.
Further notes
You disable NAT with the
You configure the MAC mode with the
You show the NAT configuration and the translation list with the
See also
show nat (client) (Page 349)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Type or speed of the interface
Module no. and port no. of the interface
command.
no nat interface
wlan client mac mode
Layer 3 functions
Values
Enter a valid interface.
command.
command.
show nat
9.1 NAT
355