Sinema; Show Sinema; Commands In The Global Configuration Mode - Siemens SCALANCE W760 Configuration Manual

Configuration

3.5 SINEMA

Further notes
You enable the function with the
You can display the status of this function and other information with the
information
You save changes to the configuration in the Trial mode with the
command.
3.5 SINEMA
3.5.1

show sinema

Description
This command shows whether the SINEMA configuration interface is enabled or disabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show sinema
Result
The setting of the SINEMA configuration interface is displayed.
3.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
80
command.
or
cli#
command.
auto-save
configure terminal
or
end exit
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show device
write startupconfig
command to change to this mode.
command and are then in the