Show Wlan Wds-List (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
show wlan wds <wdsX 0/Y>
The parameter has the following meaning:
Parameter
wdsX 0/Y
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The following WDS settings are displayed:
● Admin status
● Connection over
● Partner ID type
● Partner MAC
● Partner WDS ID
6.1.1.19
show wlan wds-list (access point)
Description
This command shows the WDS partners connected to the WLAN interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan wds-list <wlan 0/X>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
WDS interface
or
cli#
Values or range of values
Enter a valid interface.
Network structures
6.1 WLAN
133
Advertisement
Table of Contents
