Syntax
Call up the command with the following parameters:
ntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Parameter
+
-
hh
mm
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
Result
The time difference between the device and the NTP server is configured.
5.3
SNTP client
This section describes commands relevant for configuration of the SNTP client.
5.3.1
show sntp broadcast-mode status
Description
This command shows the current configuration of the broadcast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show sntp broadcast-mode status
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Time zones to the west of the NTP server time zone
Time zones to the east of the NTP server time zone
Number of hours difference
Number of minutes difference
or
cli#
System time
5.3 SNTP client
109