No Vap Broadcast Ssid (Access Point) - Siemens SCALANCE W760 Configuration Manual

Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
See also
no vap broadcast ssid (access point) (Page 189)
6.1.6.4

no vap broadcast ssid (access point)

Description
With this command, you disable the "Broadcast SSID" function. The SSID is no longer sent
in the frame of the access point. This means that the SSID is not visible for other devices.
Only stations that know the SSID of the access point and that are configured with it can
connect to the access point. The "Any SSID" option must be disabled on these clients.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
no vap broadcast ssid
Result
The function is disabled.
Further notes
You display the setting with the
You enable the function with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show wlan vap <vap X 0/Y>
no vap broadcast ssid
show wlan vap <vap X 0/Y>
command (default setting).
vap broadcast ssid
Network structures
command.
command.
command.
6.1 WLAN
189