Commands In The Vap Interface Configuration Mode; Vap Wds Id (Access Point) - Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
Result
The packet size is specified.
Further notes
You display the setting with the
6.1.6

Commands in the VAP Interface Configuration mode

This section describes commands that you can call up in the VAP Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the VAP Interface Configuration mode with the
the Global Configuration mode.
● If you exit the VAP Interface Configuration mode with the
Privileged EXEC mode.
6.1.6.1

vap wds id (access point)

Description
With this command, you set the WDS ID for the relevant VAP interface. To establish a WDS
connection, enter this WDS ID on the WDS partner.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
186
show wlan advanced <wlan 0/X>
interface vapX 0/Y
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
command to change to this
command, you return to
exit
command, you return to the
end