Commands In The Wlan Configuration Mode; Wlan Security Ap-Radius-Authenticator - Siemens SCALANCE W760 Configuration Manual

Syntax
Call up the command with the following parameters:
show wlan security-keys < wlan 0/X >
The parameters have the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The key table is displayed.
10.2.4

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the
Commands relating to other topics that can be called in the WLAN configuration mode can
be found in the relevant sections.
● If you exit the WLAN configuration mode with the
configuration mode.
● If you exit the WLAN Configuration mode with the
Privileged EXEC mode.
10.2.4.1

wlan security ap-radius-authenticator

Description
With this command, you enable the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description Range of values / note
WLAN interface Enter a valid interface.
Security and authentication
command to change to this mode.
wlan
command, you return to the Global
exit
command, you return to the
end
10.2 WLAN
363