Commands In The Interface Configuration Mode; Ip Address - Siemens SCALANCE W760 Configuration Manual

Syntax
Call up the command with the following parameters:
ip domain used server {public-only | manual-only | all}
The parameters have the following meaning:
Parameter
public-only
manual-only
all
Result
The device uses the DNS servers specified in the configuration.
7.1.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
7.1.3.1

ip address

Description
With this command, you assign an IP address to a VLAN interface.
Requirement
● Interface is a router port
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
The device uses only the DNS servers
assigned by DHCP.
The device uses only the manually con-
figured DNS servers. A maximum of
three DNS servers can be configured.
The device uses all available DNS serv-
ers.
interface
Network protocols
7.1 IPv4 protocol
Range of values
-
-
-
command to change to this mode.
command, you return to the
exit
command, you return to the
end
273