Commands In The Global Configuration Mode; Nat (Client) - Siemens SCALANCE W760 Configuration Manual

Layer 3 functions
9.1 NAT
See also
nat (client) (Page 351)
nat local ip address (client) (Page 354)
nat interface (client) (Page 355)
nat timeout (client) (Page 356)
9.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.1.2.1

nat (client)

Description
With this command, you change to the NAT Configuration mode.
Note
This command is only available in the client mode
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
nat
350
command to change to this mode.
configure terminal
or
end exit
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command and are then in the