Siemens SCALANCE W760 Configuration Manual page 292

Network protocols
7.3 DHCP server
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
option <option-code> { <ip-address-list> | int-ip }
The parameters have the following meaning:
Parameter
option-code
ip-adress-
list
int-ip
Result
The DHCP option is created.
Further notes
You display the setting with the
You disable the IPv4 address band with the
You delete the DHCP option with the
You configure the DHCP option 67 with the
You configure all other DHCP options with the
You configure the interface with the
292
Description
Code of the DHCP option
IPv4 address or IPv4 address list
Uses IPv4 address of the interface that is
assigned to the IPv4 address band.
show ip dhcp-server pools
no option
set interface
Range of values / note
3 - Router
•
6 - DNS server
•
66 - TFTP server name
•
Enter an IPv4 address. With the excep-
tion of DHCP option 3, you can specify
several IPv4 addresses separated by
commas.
-
command.
command.
no pool-enable
command.
option value-string
option value-hex
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
command.