Show Wlan Ssid-Table (Client); Show Wlan Vap (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
6.1.1.16
show wlan ssid-table (client)
Description
This command shows a table with the SSIDs of the access points to which the client device
can establish a wireless link.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan ssid-table <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The table with the SSIDs configured on the client and their status is displayed.
6.1.1.17
show wlan vap (access point)
Description
This command shows the configuration of the VAP interface.
Note
This command is available only in access point mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
cli#
Description
WLAN interface
Values or range of values
Enter a valid interface.
Network structures
6.1 WLAN
131
Advertisement
Table of Contents
