Pool-Enable - Siemens SCALANCE W760 Configuration Manual

Network protocols
7.3 DHCP server
Further notes
You configure the DHCP option 67 with the
You configure the DHCP options 3, 6 and 66 with the
You configure all other DHCP options with the
7.3.4.7

pool-enable

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command you specify that this IPv4 address band will be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
pool-enable
Result
The setting is enabled.
Note
If the IPv4 address band is activated, no DHCP options (option ...) and static assignments
(static leases) can be configured.
Further notes
You display the setting with the
You disable the setting with the
296
option value-string
option
option value-hex
show ip dhcp-server pools
command.
no pool-enable
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
command.
command.
command.