Commands In The Events Configuration Mode; Add Log - Siemens SCALANCE W760 Configuration Manual

Diagnostics
11.1 Diagnostics
Result
You are now in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Further notes
You exit the EVENTS configuration mode with the command
11.1.14

Commands in the Events configuration mode

This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
11.1.14.1

add log

Description
With this command, you create an entry in the log.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
add log <log entry>
The parameter has the following meaning:
Parameter
log entry
412
events
Description
Entry in the logbook
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
or
end exit
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
max. 150 characters
Configuration Manual, 11/2014, C79000-G8976-C351-03
.