Password - Siemens SCALANCE W760 Configuration Manual

Syntax
Call up the command with the following parameters:
tftp server {<ipv4-addr>}[port<tcp port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4-addr
port
tcp port
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The settings for the access to the selected TFTP server are configured.
3.2.4.6

password

Description
With this command, you activate and configure the password for the user certificate.
Note
This command is only available in the client mode
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Identifies the unicast IPv4 address
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Configuration
3.2 Load and Save
Range of values / note
Enter a valid unicast IPv4 address
-
1 ... 65535
71