Spanning-Tree Mst Hello-Time - Siemens SCALANCE W760 Configuration Manual

Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting is reset to the default value.
Further notes
You configure the setting with the
You display these settings and other information with the commands that start with
spanning tree ...
6.3.4.10

spanning-tree mst hello-time

Description
With this command, you configure the Hello time after which the bridge sends its
configuration frames (BPDUs).
A change to this value applies to all MST instances active on this interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst hello-time <seconds(1-2)>
The parameter has the following meaning:
Parameter
seconds
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
spanning-tree mst
.
Description
Time after which the bridge sends its
configuration frames (BPDUs)
Network structures
6.3 Spanning Tree
command (properties).
Range of values / note
1 ... 2
Default: 2
show
251