Show Vlan - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
6.2.1.5
show vlan
Description
This command shows the specific information for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or VLAN range
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Network structures
6.2 VLAN
Values
-
1 ... 4094
-
-
-
Enter a valid interface.
199
Advertisement
Table of Contents
