No Wlan Any Ssid (Client) - Siemens SCALANCE W760 Configuration Manual

Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
See also
no wlan any ssid (client) (Page 153)
vap broadcast ssid (access point) (Page 188)
6.1.5.15

no wlan any ssid (client)

Description
With this command, you disable the "Any ssid" function. The client attempts to connect to the
access point from the SSID list that provides the best transmission quality and on which the
"Broadcast SSID" option is disabled.
Note
This command is only available in the client mode.
Requirement
● An active SSID is available.
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan any ssid
Result
The function is disabled.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show wlan client <wlan 0/X>
command.
no wlan any ssid
Network structures
6.1 WLAN
command.
153