No Ip Address - Siemens SCALANCE W760 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>|/<prefix-length(0-32)>}
The parameters have the following meaning:
Parameter
ip-
address
subnet-
mask
prefix-
length
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The IP address is assigned to the VLAN interface.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, the connection will be lost!
Further notes
You delete the settings with the
You display this setting and other information with the
7.1.3.2

no ip address

Description
With this command, you delete the assignment of an IP address to a VLAN interface.
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
274
Description
IP address for the VLAN interface
Subnet mask of the corresponding subnet
Decimal representation of the mask as a
number of "1" bits
no ip address
Values
enter a valid IP address
enter a valid subnet mask
0 ... 32
command.
show ip interface
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.