Wlan Data Rate-11Abg Defaults (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
Result
The MCS indexes are assigned to the WLAN interface.
Further notes
You display the setting with the
You enable the function with the
You configure the transmission standard with the
6.1.5.28
wlan data rate-11abg defaults (access point)
Description
You can reset the selection to the default setting with this command.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11a/b/g/n is set.
● The "Use selected data rates only" function is enabled.
Syntax
Call the command without parameter assignment:
wlan data rate-11abg defaults
Result
The selection is reset to the default setting.
166
command.
show wlan data rates
wlan data rates-11n selected only
wlan mode
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
command.
Advertisement
Table of Contents
