Configuration
3.2 Load and Save
3.2.4.4
tftp save
Description
With this command, you copy a file from the file system of the device to a TFTP server. The
TFTP protocol is used for the transfer. You can also display a list of available files.
Requirement
● The name of the file is specified
● You are in the LOADSAVE Configuration mode.
The command prompt is:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp save {showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
Result
The file types are displayed or the file is copied.
Further notes
You configure the name of the file with the
3.2.4.5
tftp server
Description
With this command, you configure the access to a TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
70
Description
Shows the available files
Keyword for a file type to be loaded
Name of the file type
tftp filename
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
-
-
max. 100 characters
command.
Configuration Manual, 11/2014, C79000-G8976-C351-03