Management Access Control List; Show Authorized-Managers - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
10.3
Management Access Control List
This section describes the commands relevant for working with the management access
control list.
10.3.1
show authorized-managers
Description
This command shows the information about the configuration of the authorized managers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Parameter
ip-source
ip-address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The information about the configuration of the authorized managers is displayed.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
cli#
Description
Keyword for the network or host ad-
dress
Value for an IP address
Security and authentication
10.3 Management Access Control List
Range of values / note
-
specify a valid IP address
399
Advertisement
Table of Contents
