Wlan Antenna Cable-Length - Siemens SCALANCE W760 Configuration Manual

For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)"
Result
The additional attenuation is specified.
Further notes
You show the set value with the
6.1.5.10

wlan antenna cable-length

Description
With this command, you configure the cable length between the device and the external
antenna.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna cable-length <index(1)> <meter(0-30)>
The parameters have the following meaning:
Parameter
index
meter
Result
The cable length is specified.
Further notes
You show the set cable length with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show wlan antennas <wlan 0/X>
Description
Antenna connector
Cable length in meters [m]
Values or range of values
1
0...30
Default: 0
show wlan antennas <wlan 0/X>
Network structures
6.1 WLAN
command.
command.
149