Show Interfaces - Siemens SCALANCE W760 Configuration Manual

3.1.1.6 show interfaces ... counters
Description
This command shows the counters of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:

show interfaces

[{<interface-type><interface-id>]|{vlan<vlan-id(1-4094)>}]counters
The parameters have the following meaning:
Parameter
interface-type
interface-id
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
Result
The counters of the selected interfaces are displayed.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
cli#
Description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Configuration
3.1 System
Range of values / note
Enter a valid interface.
-
1 ... 4094
37