Wlan Any Ssid (Client) - Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
Syntax
Call up the command with the following parameters:
wlan antenna type {show-types | <index(1)> <antenna-index>}
The parameters have the following meaning:
Parameter
show-types
index
antenna-index
Result
The antenna type is specified.
6.1.5.14

wlan any ssid (Client)

Description
With this command, you enable the "Any SSID" function. This setting is activated as default.
In client mode, the access point attempts to connect to the network with the best
transmission quality and that has suitable security settings. The clients can only connect to
the access point on which the "Broadcast SSID" option is enabled.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan any ssid
152
Description
Shows a list of supported antennas
with the corresponding antenna index.
Antenna connector
Antenna index
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Values or range of values
--
1
Enter the required antenna index.
You can obtain an overview of the an-
tenna indexes available on the on the
device with the
wlan antenna type
command.
show-types
Configuration Manual, 11/2014, C79000-G8976-C351-03