Commands In The Vlan Configuration Mode; Name - Siemens SCALANCE W760 Configuration Manual

Network structures
6.2 VLAN
Result
The setting is reset to the default value.
Further notes
You configure the setting with the
You configure the VLAN ID with the
You can display the status of this function and other information with the
config
6.2.4

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
When doing this, you need to replace the
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
Configuration mode.
● If you exit the VLAN Configuration mode with the
Privileged EXEC mode.
6.2.4.1

name

Description
With this command, you assign a name to the VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
214
command.
command.
switchport pvid
switchport access vlan
command to change to this mode.
vlan $$$
placeholders with the relevant VLAN ID.
$$$
exit
command, you return to the
end
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
show vlan port
command, you return to the Global