Wlan Antenna Additional-Attenuation - Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
Syntax
Call up the command with the following parameters:
wlan ampdu frames-limit <frames(2-64)>
The parameter has the following meaning:
Parameter
frames
Result
The number of frames is specified.
Further notes
You display the setting with the
6.1.5.9

wlan antenna additional-attenuation

Description
With this command, you specify the additional attenuation caused, for example by an
additional splitter. Using the
WLAN settings violate the permitted transmit power restrictions (
selected country.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna additional-attenuation <index (1-X)> <dB(0-70)>
The parameters have the following meaning:
Parameter
index
dB
148
Description
Number of frames that are grouped to-
gether in one AMPDU data packet.
show wlan advanced-11n <wlan 0/X>
show wlan basic
Description
Antenna connector
Attenuation in decibels [dB]
command, check whether or not the current
Values or range of values
X = 1
0...70
Default: 0
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Values or range of values
2...64
Default: 32
command.
) of the
TX Power Check