Vap Security Default-Key (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Security and authentication
10.2 WLAN
Result
The encryption method is configured.
Further notes
You display the settings with the
10.2.6.3
vap security default-key (access point)
Description
With this command, you specify which WEP key from the key table is used for encryption.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap security default-key <index (1-4)>
The parameter has the following meaning:
Parameters
index
Result
The WEP key is specified.
Further notes
You display the settings with the
390
show wlan security <vapX 0/Y>
Description
Index of the key table
show wlan security <vapX 0/Y>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
Values or range of values
1...4
command.
Configuration Manual, 11/2014, C79000-G8976-C351-03
Advertisement
Table of Contents
