Commands In The Wlan Configuration Mode; Wlan Ipcf-Mc - Siemens SCALANCE W770 Series Configuration Manuals

Functions specific to SCALANCE
5.6 iPCF-MC
Syntax
Call the command without parameter assignment:
show wlan ipcf-mc
Result
The iPCF_MC settings are displayed.
5.6.2

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can be
found in the relevant sections.
● If you exit the WLAN configuration mode with the exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the end command, you return to the
Privileged EXEC mode.
5.6.2.1

wlan ipcf-mc

Note
The command is only available if the SCALANCE W700 device supports iPFC-MC or the
function can be enabled.
● iPCF-MC is enabled with the aid of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5 907-8PA00)
– W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
With this command, you enable iPCF-MC on this SCALANCE W700 device.
Requirement
● You are in the WLAN configuration mode.
The command prompt is as follows:
cli(config-wlan)#
● The access point has at least two WLAN interfaces (dual AP).
● Access point mode: Only dual APs with KEY-PLUG W780 iFeatures (MLFB 6GK5
907-8PA00)
140
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08