Chrysler 2005 Crossfire SRT6 Service Manual page 1130

8L - 64 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*RIGHT BACK UP LAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT BACK UP LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Move the transmission shift lever into reverse.
Measure the voltage between the Right Rear Lamp Assembly harness
connector cavity 5 and ground.
Is voltage present?
Yes >> Go to 4
No >> Replace the Illumination Control Module.
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT BACK UP LAMP GROUND CIRCUIT RESISTANCE
Move the transmission shift lever into park.
Turn the ignition off.
Measure the resistance between the Right Rear Lamp Assembly har-
ness connector and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Back Up Lamp bulb is installed
properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Rear Lamp Assembly ground circuit for
an open.
Perform BODY VERIFICATION TEST.
ZH