Chrysler 2005 Crossfire SRT6 Service Manual page 1582

8R - 12 WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
*WASHERS RUN CONTINUOUSLY WITH IGNITION ON (CONTINUED)
2.
MEASURE MULTI-FUNCTION SWITCH RESISTANCE
Note: If any BCM DTCs are set, diagnose them first before con-
tinuing.
Turn the ignition off.
Disconnect the Multi-Function Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Multi-Function Switch between cavity 8
and cavity 11.
While measuring the resistance, depress the washer switch once and
release.
Did the resistance reading go from infinite to less than 5 ohms
to infinite?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL)
Perform BODY VERIFICATION TEST.
No >> Replace the Multi-Function Switch. (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/MULTI-FUNCTION
SWITCH - REMOVAL)
Perform BODY VERIFICATION TEST.
ZH