Table of Contents
Advertisement
ZH
*HIGH BEAM INDICATOR INOPERATIVE (CONTINUED)
2.
MEASURE HIGH BEAM INDICATOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect the Illumination Control Module harness connector.
Measure the resistance of the High Beam Indicator circuit from the Illu-
mination Control Module harness connector cavity 7 to the Instrument
Cluster C1 harness connector cavity A2.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the High Beam Indicator circuit for an open.
Perform BODY VERIFICATION TEST.
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 51
Advertisement
Chapters
Table of Contents
