Chrysler 2005 Crossfire SRT6 Service Manual page 1109

ZH
*RIGHT REAR SIDE MARKER LAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT REAR SIDE MARKER LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the side marker lamps on.
Measure the voltage between the Right Rear Side Marker Lamp har-
ness connector cavity 2 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT REAR SIDE MARKER LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the side marker lamps off.
Measure the resistance between the Right Rear Side Marker Lamp
harness connector cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Rear Side Marker Lamp bulb is
installed properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Rear Side Marker Lamp ground circuit for
an open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 43
- EXTERIOR/HEAD-